Phillips Hardware Voorheesville Schenectady Waterford Altamont Small Engine Repair Blade Sharpening Window Repair Screen Repair Propane Glass Cu

ALTAMONT

518-861-5364

DELMAR

518-439-9943

SCHENECTADY

518-346-4383

VOORHEESVILLE

518-765-2377

WATERFORD

518-233-1073

Phillips Hardware Tips: Waterproofing

 

Finish getting the inside of the house ready before go you outside for the spring!

 

Waterproofing True Value Phillips Hardware Delmar Voorheesville Schenectady Waterford AltamontWant to spruce up your laundry room in the basement but concerned about all the snow leaking into your space? Ten loads of laundry would take just over 12 hours to complete. That is a lot of time spent in a damp and dreary space. Pictured here is a laundry space brightened up with tinted DRYLOK Extreme Masonry Waterproofer. The main wall was tinted to Buttercup and the accents were tinted to Mint Green. You can change your space into something more welcoming and waterproof it before the snow melts!

 

Prepare the Surface

Clean the surface thoroughly with a wire brush to remove any loose or broken mortar and dirt from the surface. If you see white, powdery deposits (efflorescence) it must be removed. Treat efflorescence by washing with a solution of DRYLOK® Etch (liquid or powdered formula) or muriatic acid according to manufacturer’s directions, rinse and allow to dry. Efflorescence occurs naturally and may recurring but is easy to treat again if needed.

 

Patch Cracks and Holes

Fill all holes and cracks with DRYLOK® Fast Plug®. Wet down and back chisel the area, to the shape of an inverted “V” this allows the patch to lock into the surface and cure properly. Fast Plug® sets up rapidly, so only mix enough patch to be used in 3 to 5 minutes.

 

Seal the Floor and Wall Joint

When patching, don’t forget the area where the floor and wall meet.  Often, when concrete floors cure, they shrink and pull away from the wall, allowing a space for water to enter.  Fill this area with DRYLOK® Fast Plug® also and then apply DRYLOK® To Masonry Walls. Stir DRYLOK® thoroughly before and during application. Apply using a 3/4 in. nap roller, DRYLOK® Brush or good quality nylon bristle brush. If rolled, back-brush the first coat to fill any pinholes in the masonry.  DRYLOK® must be worked into the pores of the masonry, making sure to fill all pores and pinholes. Proper coverage is important for waterproofing, 1 gallon covers a 8 ft. x 10 ft. area. A minimum of two coats is required to assure waterproofing. Allow the DRYLOK® to dry between coats following the label instructions.

Important:  After the second coat dries, inspect entire wall surface for pinholes in the waterproof coating.  Any areas with pinholes should be painted with an additional coat to ensure waterproofing results.

 

Waterproofing True Value Phillips Hardware Delmar Voorheesville Schenectady Waterford AltamontAll these products are available at your local hardware store and the employees at Phillips Hardware can help you with any home improvement projects.

 

Visit Any Of The Phillips Hardware Locations

Delmar Location

235 Delaware Ave,

Delmar, NY 12054

Phone: 518-439-9943

M-F 8am-8pm

Sat 8am-6pm, Sun 9am-5pm

 

Voorheesville Location

18 South Main St,

Voorheesville, NY 12186

Phone: 518-765-2377

M-Sat 8am-6pm, Sun 9am-5pm

 

Altamont Location

6495 Rt 158,

Altamont, NY 12009

Phone: 518-861-5364

M-Sat 8am-6pm

Sun 9am-5pm

 

Schenectady Location

1729 Union Street,

Schenectady, NY12309

Phone: 518-346-4383

M-Sat 8am-6pm, Sun 10am-3pm

 

Waterford Location

42 Saratoga Ave,

Waterford, NY 12188

Phone: 518-233-1073

M-Fri 8am-7pm

Sat 8am-6pm, Sun 9am-5pm

 

 

Copyright 2017 by A. Phillips Hardware

Phillips Hardware Corporate Office

Phone: 518-459-2300

phillips.hardware@shopphillips.com

Groupiehead Website Design Social Media Marketing Albany NY